admin 24 February, 2019 0

CPSC GOV PSSA PDF

If you just had a baby, are expecting, or are taking care of a young infant it’s important to create a safe sleep environment for your baby. Because babies spend. Federal law requires that bunk beds comply with the bunk bed standard and with additional requirements, including those of the Consumer Product Safety. Product Safety Commission (CPSC) handbook offers guidelines for pool . This section explains the CPSC swimming pool barrier .. Web site:

Author: JoJosida Kajizragore
Country: Yemen
Language: English (Spanish)
Genre: Literature
Published (Last): 17 June 2011
Pages: 249
PDF File Size: 17.5 Mb
ePub File Size: 9.48 Mb
ISBN: 122-8-74251-376-6
Downloads: 90900
Price: Free* [*Free Regsitration Required]
Uploader: Fenrikus

This rule seeks to prevent the risk of deaths and injuries of children from being trapped between an upper bunk and a wall, in openings below the guardrails, or in openings in the ends goc bunk beds.

CFOC Standards Database | National Resource Center

Supervising adults should be CPR-trained and should have a telephone accessible to the pool and water area at all times should emergency services be required. Consumer Product Safety Commission:. With no mattress on the upper bunk, any space between the bottom of the guardrail and the top of the mattress foundation must not let the wedge block pass through freely.

These rings usually contain three or four legs with suction cups that attach to the bottom of the tub. If the guardrail does not attach to an end of the bed, the gap between the end of the guardrail and the nearest end of the bunk bed cannot be greater than 0. It is nearly impossible for top-heavy their heads infants and toddlers to free themselves when they fall into a five-gallon csc head first 8.

A guardrail on the side of the bed away from the wall does not have to run continuously from end to end of the bed, BUT the distance between either end of the guardrail and the end of the bed cpcs to it cannot be greater than 15 inches.

The link you selected is for a destination outside of the Federal Government.

Chapter 2: Program Activities for Healthy Development

Because of the detail involved in performing the test, the test procedure is not summarized here. How do you test a bunk bed for entrapment hazards? See the illustration of the wedge block below. Consumer Product Safety Commission: What does the bunk bed rule require?

  DON DELILLO PAFKO AT THE WALL PDF

No opening in either end of the upper bunk that is above the mattress foundation can let the wedge block pass through freely. Constant and active supervision should be maintained when any child is in or around water 1. Any views expressed in this communication may be changed or superseded by the Commission.

Inapproximately 1, children under the age of twenty in the U. For more information on the requirements for bunk beds, contact the U. The Centers for Disease Control CDC National Center for Injury Prevention and Control recommends that whenever young children are swimming, playing, or bathing in water, an adult should be watching them constantly. Program Activities for Healthy Development 2. The ends of a bunk bed are the upright parts at the head and foot of the bed to which you attach the side rails.

When testing spaces between the guardrail and upper mattress foundation, pull the wedge gradually, and sustain a force of 33 foot-pounds for 1 minute. Bunk beds that are designed or intended for children 12 years of age or younger are subject to surface coating requirements, lead and phthalate content limits, testing and certification, and tracking label requirements.

Bunk beds for children may not have sharp points or edges. Are there any standards that apply to bunk beds?

When the thickest mattress and mattress foundation recommended by the manufacturer are used, the top of each end of the upper bunk must extend at least 5 inches above the top of the mattress, and that 5-inch margin of safety must extend at least half of the distance between the corner posts of each end. The need for constant supervision is of particular concern in dealing with very young children and children with significant motor dysfunction or developmental delays.

You may wish to review the privacy policy of the external site as its information collection practices may differ from ours. What is a bunk bed? Office of Compliance for specific enforcement inquires: Of all buckets, the five-gallon size presents the greatest hazard to young children because of its tall straight sides and its weight with even just a small amount of liquid.

An infant also may slip between the legs of the bath ring and become trapped under it. Supervision Near Bodies of Water. Bunk bed requirements call for a specific warning label AND a label or marking that provides the name and address of the manufacturer or importer, model number, and month and year of manufacture. Where can I find the requirements for bunk beds? Thirty children under five years of age died from drowning in buckets, pails, and containers from Any opening in the headboard or footboard of the lower bunk below the mattress foundation of the upper bunk tested with the wedge block must also be tested for the risk of neck entrapment if the opening lets the 9-inch sphere pass though freely.

  DESCARGAR SOBIBOR JEAN MOLLA PDF

This communication has not been reviewed or approved by the Commission, and does not necessarily represent their views.

The suction cups, however, may release suddenly, allowing the bath ring and infant to tip over. These requirements are discussed below: A bunk bed is a bed with the bottom of its mattress foundation more than 30 inches above the floor.

The tracking label, to the extent practical, requires basic information, including the source of the product, date of manufacture, and cohort information, such as a batch or run number.

CPSC does not control this external site or its privacy policy and cannot attest to the accuracy of the information it contains. If the sphere passes through freely, test the opening for neck entrapment. Children’s bunk beds cannot contain greater than ppm 0. Children’s bunk beds may not be painted with paint that contains more than 0. Similarly, Section 14 a 5 of the CPSA requires a children’s product and its packaging to have a tracking label or other distinguishing permanent mark.

No opening in the headboard or footboard of the lower bunk below the mattress foundation of the upper bunk and above the mattress foundation of the lower bunk cpxc permit the wedge block to pass through freely – UNLESS the opening also allows a rigid 9-inch sphere to pass through it freely.

Are there any additional requirements for bunk beds?